Removal From Operation - Empasa CZGB-S Montage- Und Bedienungsanleitung

Operating for first time
IMPORTANT!
• If the pilot does not ignite or goes out, turn the regulator dial to the "OFF" position. A 5-minute wait is required before
attempting to ignite again. Make sure that the regulator dial is in the "OFF" position before reattempting to ignite the gas
heater.
• If a new gas cylinder has recently been connected, allow the air in the gas line to disperse through the pilot opening
for at least one minute.
• When igniting the pilot light, make sure that the dial is held down whilst the igniter button is pressed. The dial can be re-
leased once the pilot light is burning.

Removal from operation

IMPORTANT!
To turn off the gas heater:
1. Press and turn the dial to the "OFF" position.
2. Close the valve on the gas cylinder completely.
NOTE:
• Do not touch or move the gas heater for at least 45
minutes after use.
CAUTION: BURN HAZARD!
• Allow all burner components to cool before touching.
V1/2020_EM/CZGB-S 41