Safety Instructions - Empasa CZGB-S Montage- Und Bedienungsanleitung

Safety instructions

Warning
• Assembly and repairs must be carried out by a qualified professional/service technician.
• Improper assembly, modifications or changes can result in damage to one's person or property.
• Do not attempt to modify this gas heater in any way.
• The assembly of the gas heater and the storing of the propane cylinders must be carried out in accordance with applicable
provisions.
• Do not move the gas heater during operation.
• Close the valve on the cylinder and the regulator before moving the gas heater.
• The tube or flexible hose must be replaced once a year.
• Take precautions that the gas heater will not tip over in strong winds.
• Do not store or use petrol or other flammable gases or liquids in the heater.
• Before using, check the entire gas system, the hose control, the pilot flame igniter and the burner for leaks or damage.
• All leak checks should be done with a soap solution. Never use an open flame to check for leaks.
• Do not use the gas heater until it has been tested for leaks.
• If you smell gas, shut the gas valve immediately.
• Do not move the gas heater during operation.
• After operation, wait until the gas heater has cooled down before moving it.
• Keep the air vents of the gas cylinder housing clean and free of debris.
• Do not apply paint to the radiant screen, control panel or top canopy reflector.
• The gas heater's control panel, burner and circulation air passageways must be kept clean.
• More frequent cleaning may be required as necessary.
• Keep the LPG cylinder turned off when the gas heater is not in operation.
• Check the gas heater immediately in the event of the following:
• The gas heater does not give off sufficient heat.
• The burner makes popping noises during operation (light popping noises may be heard when the burner is turned off –
this is normal).
• Gas odour in connection with a flame with a very yellow tip.
• Do not place the LPG regulator/hose assembly must be located out of pathways where people may trip over it and areas
where it may be damaged accidentally.
• If removed for maintenance purposes, all protective cladding and safety elements must be reattached prior to use of the gas
heater.
• Replace the gas cylinder in a well-ventilated area away from combustion sources.
• Test whether the regulator seal is correctly fitted and in good condition.
• Do not block the casing's ventilation holes.
• Keep both adults and children away from the hot surface to prevent risk of burns and combustion of clothing.
• Children must be carefully supervised when in the proximity of the gas heater.
• Do not hang articles of clothing or other flammable materials on or near the gas heater.
• The rubber hose can be replaced by the user. Please note that the hose length must be 100 cm and must meet national regu-
lations.
• Liquid petroleum gas (LPG) properties: flammable, explosive, heavier than air and sinks to the floor.
• Propane in its natural state has no odour. For your safety, an odorant has been added that smells like rotting cabbage.
• Skin which comes in contact with LPG can become frostbitten, with wounds similar to burns.
• This gas heater is made to be used only with propane, butane or a propane-butane mix (normally called liquid petroleum gas,
or LPG).
• Use only 11 kg LPG cylinders which meet local regulations (the same type normally used with gas barbecue grills) with safety
valves.
V1/2020_EM/CZGB-S 30