Herunterladen Inhalt Inhalt Diese Seite drucken

AirPower twintorque Bedienungs- Und Wartunsanleitung Seite 12

Vorschau ausblenden Andere Handbücher für twintorque:
Inhaltsverzeichnis

Werbung

Installation
Installation
Montage der Federn
Achtung! Die Deckel des Schwenkantriebes nur
im drucklosen Zustand montieren. Demontieren
Sie die Deckel des Schwenkantriebes. Setzen
Sie die ausgewählte Anzahl Federn in die Federtaschen
der Kolben ein. Die Anordnung der Federn gemäß der
unten aufgeführten Abbildung „1" einsetzen. Montieren
Sie die Deckel des Schwenkantriebes. Hierbei sind die
Schrauben gemäß Abbildung „2" anzuziehen. (Schrau-
benanzugsmomente siehe Seite 13)
Abbildung „1"
No. springs
Piston left
Federzahl
Kolben links
4
5
6
Abbildung „2" / Illustration „2"
Piston right
Kolben rechts
12
Inserting the springs
Attention! Mount the cover only in a pressure-free
situation
Remove the cover from the actuator. Place the
selected number of springs into the holes in the piston.
The positioning in the holes is done according one of the
systems shown in illustration "1". Place the end covers
in position, insert the screws and tighten in position.
When tightening the screws, make sure to keep to the
tightening sequence as shown in illustration "2" (for
tightening torques- please consult page 13).
Illustration „1"
No. springs
Piston left
Federzahl
Kolben links
7
8
9
10
11
12
Piston right
Kolben rechts

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis