Checking The Fuel Tank Level - Zipper Maschinen ZI-RPE60 Betriebsanleitung

15.3.2 Checking the fuel tank level

1. Screw on the tank cap (sits on the fuel tank).
2. Level check in the form of a visual inspection. If necessary, top up with fuel
3. Close the fuel filler cap tightly after refuelling.
16 OPERATION
 Save the working environment before you start compressing.
 Only put the machine into operation after you have read and understood the safety
instructions and carried out the necessary measures before initial commissioning.
 The correct moisture content of the soil is very important for correct compaction.
Compaction of dry materials is facilitated by moistening the material. Too much
moisture, on the other hand, leaves water-filled cavities which weaken the load-
bearing capacity of the soil.
 Wetness or excessive irrigation can lead to overloading and engine death.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RPE60 ZI-RPE9035
Observe the safety regulations for fuel control. Filter the fuel during refuelling to
prevent foreign particles from entering the combustion chamber. Wipe up leaked fuel.
with the appropriate octane number (RON 95).
1. To check the engine oil level, place the machine
on a safe, level surface. Switch off the engine and
allow the machine to stand for ten minutes so that
the circulating oil can collect in the oil pan.
2. Unscrew the oil dipstick and wipe with a clean,
lint-free cloth or a non-fibrous paper towel.
3. Push the dipstick into the opening, but do not
screw it in. (Make sure that the dipstick has really
been pushed in completely).
4. Pull out the oil dipstick again and read off the oil
level. There are two markings for this - see
illustration on the left.
5. If the oil level is low, refill the recommended oil up
to the upper edge (maximum filling volume:
approx. 0.5 litres).
6. Push in the oil dipstick again and tighten.
N O T I C E
OPERATION
35