Checking The Fuel Tank Level; Operation; Information On Initial Start-Up; Test Run Initial Start-Up - Zipper Maschinen ZI-RPE60C Betriebsanleitung

15.3.2 Checking the fuel tank level

1. Screw on the tank cap (sits on the fuel tank).
2. Level check in the form of a visual inspection. If necessary, top up with fuel
3. Close the fuel filler cap tightly after refuelling.
16

OPERATION

 Save the working environment before you start compressing.
 Only put the machine into operation after you have read and understood the safety
instructions and carried out the necessary measures before initial commissioning.
 The correct moisture content of the soil is very important for correct compaction.
Compaction of dry materials is facilitated by moistening the material. Too much
moisture, on the other hand, leaves water-filled cavities which weaken the load-
bearing capacity of the soil.
 Wetness or excessive irrigation can lead to overloading and engine death.

16.1.1 Test Run Initial Start-up

 Let the machine run idle for about 3 minutes.
 Pay attention to abnormal noises.
 Pay attention to the exhaust fumes (too black, too white)?

16.1.2 Notes on the first 20 operating hours

In order to optimize the life expectancy of your machine, the following points should be observed:
 Do not operate the engine for the first 20 operating hours @ maximum load (this also
applies to used engines after extensive maintenance). This means lower speed and lower
maximum working load than during normal operation.
 Change the engine oil after the first 20 hours of operation.

Operating Instructions

 Never use the recoil-starter while the engine is running. This will damage the engine.
 The pull mechanism for changing the engine speed is limited by an adjusting screw. This is
factory set. Never change this setting on your own, you could overload the motor.
 Do not operate the machine on slopes of more than 20°, as even with an optimum oil level
the engine may not be supplied with sufficient lubrication.
 In the direction of the vibratory plate and within a range of one meter around the vibrator,
nobody but the operator must stand.
 During the compaction the soil should first be compacted about 10 to 15 cm inside the
edge two to three times, then the edge should be compacted.
 When working inside the building, the vibrating plate or eccentric block must not attach
the walls.
 If several vibrator plates are used simultaneously on one surface, the parallel distance
between the machines should not be less than five metres and the distance between the
front and rear machines should not be less than ten metres.
ZIPPER MASCHINEN GmbH
ZI-RPE60C & ZI-RPE90C31
Observe the safety regulations for fuel control. Filter the fuel during refuelling to
prevent foreign particles from entering the combustion chamber. Wipe up leaked fuel.
with the appropriate octane number (RON 95).

Information on Initial Start-up

Note that the machine is delivered without fuel. Make sure that this equipment is
filled up before the machine is put into operation for the first time.
ATTENTION: The machine does not start until the engine oil has been refilled to
the upper limit.
www.Zipper-Maschinen.at
N O T I C E
N O T I C E
OPERATION
31