5
GETTING STARTED
Installation
• Install the fitting module you would like to use with EXPRESSlink
your computer. For installation information, please refer to the instal-
lation instructions from the fitting module supplier.
• Attach EXPRESSlink
The flat connector on the USB cable plugs into the computer and the
square connector plugs into the rear of EXPRESSlink
figure below:
• Several seconds after connecting EXPRESSlink
power indicator on the front panel of EXPRESSlink
• Plug the hearing aid programming cables into the connectors on the
front panel of the EXPRESSlink
• Your EXPRESSlink
Note:
The driver software for EXPRESSlink
module. In case the fitting module is uninstalled or updated, the driver
software will remain installed. Updates to the EXPRESSlink
delivered with your fitting software.
6
Downloaded from
www.Manualslib.com
to the computer using the USB cable provided.
3
EXPRESSlink3_ILLU_Fig4
is now ready to use.
3
To reduce the risk of interference use only the USB cable pro-
vided or a standard USB cable that is less than the maximum
length of 3m.
manuals search engine
to the computer, the
3
.
3
is included in the fitting software
3
on
3
as shown in the
3
turns bright green.
3
driver are
3