Troubleshooting - Zipper ZI-DS2V-AKKU Original Bedienungsanleitung

18
In case of leakage or poor
spraying performance
Extra-high pumping pressure
Extra-small pumping pressure
Spray air instead of water
Note: only thoroughly cleaned sprayers are allowed tob e sent in for repair!
Z.I.P.P.E.R Maschinen Austria
Drucksprüher / Garden Sprayer ZI-DS2V-AKKU
Downloaded from www.Manualslib.com

TROUBLESHOOTING

PROBLEM
www.Zipper-maschinen.at
manuals search engine
CAUSES
Seal rings at various
joints may loose or be
damaged.
The switch filter screen
or the small filter screen
at the suction hose has
been blocked.
The spray hole has been
blocked.
Poor lubrication of
piston O-ring.
Extra-high pressure in
the tank
Piston O-ring is worn out
or damaged
Water-proof washer
comes off
The suction hose in the
tank comes off
TROUBLESHOOTING
SOLUTIONS
Tighten or replace it
Clean it
Clean and repair it.
Apply grease to the
piston O-ring
Stop boosting. Check
the relief valve for
possible jamming. Apply
grease to the O-ring of
relief valve
Replace the piston
O-ring
Repair.
Fix it
Seite 30