Fermax DUOX Skyline Installationshandbuch Seite 35

Desde una placa con teclado se puede realizar un Reset de
parámetros a valores por defecto de fábrica. Ver la Tabla de
confi guración a través del código QR disponible en la parte trasera
del amplifi cador o el manual de Programación Placas Direct, cod.
97701, en www.fermax.com.
RESTORE DEFAULT VALUES: Reset
RESET Mapping (call button code)
1. Reset amplifi er: remove power.
2. Press the SW1 button, connect the power supply and maintain
the SW1 button pressed 5 seconds until you hear the reset
confi rmation sound: beep-beep.
Lock release times
To change the lock-release times see:
- If using a button panel, see Voice assisted confi guration.
- If a DIRECT panel (with keypad), these parameters are
programmed via the keypad.
Both instructions are available via the QR code on the back of the
amplifi er or at www.fermax.com.
RESET Programming Code from keypad panels
You can reset the programming access code (if the previous one is
forgotten), to the default code.
Pag 35