Fermax DUOX Skyline Installationshandbuch Seite 19

Confi guration - Programming the Amplifi er
The DUOX amplifi er can be confi gured to allow for the operation as
a general entrance, block entrance or sub-block entrance.
• The DUOX system uses 6 digit house terminal addresses.
• These call code digits are organised as follows: BBSSNN:
- BB: indicates the Block number, (from 00 to 99).
- SS: indicates the sub-Block number, (from 00 to 99).
- NN: indicates the sub-Block house number, (from 00 to 99).
You do not have to segregate the installation according to this
hierarchy since the system adapts to the installation´s needs.
IMPORTANT NOTE:
Confi guration of the parameters by the installer.
- You can confi gure the BUTTONS via the voice assisted programming. VSee
instructions available via the QR code on the back of the amplifi er or at www.
fermax.com.
- For DIRECT panel confi gurations (with keypad), these parameters are
programmed via the keypad. See the Confi guration Table via the QR codes
available on the back of the amplifi er or at www.fermax.com.
Pag 19