Maintenance And Cleaning - Zelmer ZMM2851B Benutzerhandbuch

PL EN
Operational approach:
Fix the assembled appliance on the stable surface, turn on the power switch, embed the clean-washed
casing into the discharge port (for fastening) after confirming the normal operation of the appliance, put
the marinated food into the material plate, and push it into feed port by feeder push.
Please disconnect the power plug after use.
Scope of application: a variety of meat without bone or tendon, meat and seasoning mixture.
Making mashed potato and garlic
Important notice: the installation method for making mashed potato and garlic is same as that of juicer,
except replacing juicer mesh tube in step 2 with mashing cylinder and replacing juicer nozzle with
mashing nozzle in step 4.
Operational approach:
Fixed the assembled appliance on the stable surface, cut the potato (peeled garlic) into strip of
approximately 20mm×20mm×20mm and put them into material plate.
Turn on the power switch and slowly press the food into feed port by feeder push after confirming normal
operation of the appliance.
Disconnect the power supply after use and take processed food away.
Important notice: the installation method of making noodles is same as that of juicer, except replacing
juicer mesh tube in step 2 with mashing cylinder and replacing juicer nozzle with round-noodle/ linguine
nozzle in step 4.
Operational approach:
Fix the assembled appliance on the stable surface and put the duff into material plate.
Turn on the power switch and slowly put the duff into feed port after confirming the normal operational of
the appliance.
Disconnect the power supply after use.
Shred and Slice
Installation method:
Step 1: hold and tilt the tee-junction of shred and slice toward the switching push button at about 45
degrees embedded in the output gear, anticlockwise screw in the body for fastening and the lock button
will automatically fix the tee-junction. (Fig.18)
Step 2: upward open the tee-junction of shred and slice and put the cutter in (select cutter of thick
filament, thin filament and slice as needed). (Fig.19)
Step 3: tighten the tee-junction cover of shred and slice, and fix the assembled appliance on the stable
surface. (Fig.20)
Operational approach:
Put the prepared fruits or vegetables in the material plate.
Turn on the power switch, put the food into feed port in turns after confirming the normal operation of the
appliance and press the food by feeder push.
Scope of application: pumpkin, cucumber, sponge gourd, potato, sweet potato, carrot and other fruits or
vegetables with fine fibers.
Note: in case food locked on the screw out of work during the operation, immediately turn off the power
supply.

MAINTENANCE AND CLEANING

Before cleaning, always turn off the appliance and unplug it from the power supply.
Do not immerse the appliance and power cord in water or other liquids or wash them in the dishwasher.
14