Making Sausages; Maintenance And Cleaning - Zelmer ZMM1011 Benutzerhandbuch

AF-MANUAL_MEAT GRINDER ZELMER ZMM1011.pdf
Step 3: attach the mesh sieve to the blade (select mesh sieve as needed), and lock the half slot of mesh
sieve to the adjusting pin of tee-junction (as shown in the picture). (Fig.3)
Step 4: press on the center of the mesh sieve with one hand and screw the aluminum alloy cap with the
other hand (as shown in the picture). (Fig.4)
Step 5: hold and tilt the tee-junction of minced meat toward the switching push button at about 45 degrees
embedded in the output gear, anticlockwise screw in the body (as shown in the picture) for fastening, and
the lock button will automatically fix the tee-junction. (Fig.5)
Step 6: put and fix the material plate into the tee-junction, and fix the assembled appliance on a stable
surface. (Fig.6)
Operational Approach:
Cut the meat into long strip of about 20mm×20mm×60mm (meat without bone or tendons is recommen-
ded) and put it into the material plate，
Turn on the power switch, and put the prepared meat into feed port of tee-junction in turn after confirming
the normal operation of the appliance.
In case the food failed to be automatically drawn into the meat screw, slowly press the food with feeder
push. (Feeder push is allowed only).
Please disconnect the power plug after use.
Note: in case food locked in the screw out of work during the operation, immediately turn off the power.
C
M

Making Sausages

Y
Installation method:
CM
Step 1: put the screw of minced meat into the tee-junction (as shown in the picture). (Fig.7)
MY
Step 2: assemble sausage filter (as shown in the picture). (Fig.8)
CY
Step 3: put the sausage tube into the tee-junction (as shown in the picture). (Fig.9)
Step 4: screw up the aluminum alloy cap (as shown in the picture). (Fig.10)
CMY
Step 5: hold and tilt the tee-junction of minced meat toward the switching push button at about 45 degrees
K
embedded in the output gear, anticlockwise screw in the body (as shown in the picture) for fastening, and
the lock button will automatically fix the tee-junction. (Fig.11)
Step 6: put and fix the material plate into tee-junction. (Fig.12)
Operational approach:
Fix the assembled appliance on the stable surface, turn on the power switch, embed the clean-washed
casing into the discharge port (for fastening) after confirming the normal operation of the appliance, put the
marinated food into the material plate, and push it into feed port by feeder push.
Please disconnect the power plug after use.
Scope of application: a variety of meat without bone or tendon, meat and seasoning mixture.

MAINTENANCE AND CLEANING

Before cleaning, always turn off the appliance and unplug it from the power supply.
Do not immerse the appliance and power cord in water or other liquids or wash them in the dishwasher.
Prompt: it is suggested that clean the appliance immediately after use, which is
easy for cleaning.
In the event of disassembling the appliance, rotate the appliance on the
opposite direction of installation direction.
When disassembling all tee-junctions, press on the lock button 1 with one hand and screw off the tee-junc-
10
10 18/3/21 16:48
EN