Seto POWERATOR 1800 compact Gebrauchsanleitung Seite 25

4. turn the choke lever to the |
necessary if the engine is warm.
5. pull the starter handle slowly until resistance is felt.
This is the "Compression" point. Return the handle to
its original position and pull swiftly. Do not fully pull
out the rope. after starting, allow the starter handle
to return to its original position while still holding the
handle. Grasp the carrying handle firmly to prevent
the generator from falling over when pulling the
recoil starter.
INFORmATION!
Do not just let go of the rope after starting, but
lead it to its original position with the hand.
6. Warm up the engine.
Downloaded from www.Manualslib.com
| position. Not
manuals search engine
7. turn the choke lever back to the operating posi-
tion.
8. Warm up the engine without a load for a few
minutes.
2. USING ELECTRIC POWER
all commercial consumers with 230V ac voltage
(50Hz) and a maximum total power of 1.5kW can be
operated.
1. AC APPLICATION
(a) check the ac pilot lamp for proper voltage.
(b) turn the economy control switch to the "ON"
position.
(c) turn off the switch(es) of the electrical appliance(s)
before connecting to the generator.
(d) Insert the pulg(s) of the electrical appliance(s) into
the receptacle.
25