Operating Mode/ Status Description - PowerWalker VFI 6000 CG PF1 Bedienungsanleitung


15: I nverter voltage adjustment
I nterface

16: Output voltage calibration
I nterface

3-8. Operating Mode/ Status Description

I f parallel UPS systems are successfully set up, it will show one more screen with "PAR" in parameter 2 and
be assigned number in parameter 3 as below parallel screen diagram. The master UPS will be default
assigned as "001" and slave UPSs will be assigned as either "002" or "003". The assigned numbers may be
changed dynamically in the operation;
Operating mode/ status
AC mode
Downloaded from www.Manualslib.com
Setting
Parameter 2:
voltage
Parameter 3:
value is 0V.
Setting
When the output voltage can not be detected(less than 50VAC),
this menu will be reserved, "
2 and parameter 3.
Parameter 2:
Parameter 3:
output voltage, and you can calibrate it by pressing
according to the measurement from an external voltage meter.
The calibration result will be effective by pressing
calibration range is limited within + / -9V. This function is normally
used for parallel operation.
Description When the input voltage is within acceptable range, UPS will provide pure
and stable AC power to output. The UPS will also charge the battery at
AC mode.
LCD display
manuals search engine
Add
you may choose or
the voltage range is from 0V to 6.4V, the default
" will be displayed in parameter
OP.V
it always shows as output voltage.
it shows the internal measurement value of the
20
Sub
to adjust inverter
Up Dow n
or
Enter
. The