Lelit PS21 Bedienungsanleitung Seite 5

Email: zavod.par@gmail.com
COMPONENTS:
1. Safety cap
2. Wand seat
3. Iron button with red led
4. Boiler button with red led
5. Low water light indicator
6. Iron plate temperature regulating knob
7. Steam button
USER INSTRUCTIONS:
1. Remove the ironing machine from its packing and make sure all packing parts have been
taken off (including the protection bags). Lay the machine on a flat and steady surface fitted
to support it next to a wall socket (max. mt. 1,5).
2. It is recommended to lay the iron on the supplied pad.
3. Insert in the right seat (2) the supplied wand to hold the hose up and hook it with the spring
up to the iron-boiler connecting wire.
4. Unscrew the safety cap (1) and let the internal air out. Fill the boiler with max. 1,1 litres of
water
Use the funnel supplied, making sure you do not overfill the tank.
5. Close the safety cap (1).
6. Insert the plug into the main supply point; switch on boiler (4) and iron button (3). If the two
buttons come on, iron and boiler are working.
7. Turn the iron plate's temperature regulating knob (6) to the position "cotton ººº" (indicated on
the iron knob).
8. Wait that the boiler button's red light (4) goes off (it takes about 10 minutes). While ironing,
the boiler button's red light (4) normally comes on.
9. The machine is ready for use.
10. Push the steam button (7).
11. In case the steam stops during ironing and the low water light indicator (5) comes on, it
means that there is not enough water in the tank. To start ironing again, switch off the boiler
button (4); press the steam iron button (7) to ensure there is no more steam in the boiler,
slowly open the pressure cap (1), disconnect the plug and refill to the required level. Fill the
boiler with warm water and wait for it to build up pressure again.
12. When you first press the steam button (after having turned the boiler on and depressed the
steam button on the iron) you might notice a decrease in pressure. This is because the tank
has air in it. In order to have plenty of steam (after you have depressed the iron) wait until
the pressure goes back up to the maximum level before you begin.
CAUTION:
Do not leave the machine unattended while the plug is connected to the socket.
-
The iron reaches very high temperatures and it keeps being very hot even 15 minutes after
-
it's been switching off. Be careful not to burn yourself.
For complete safety, before filling the boiler, please disconnect the plug.
-
While using the machine and 15 afterwards the iron plate has very dangerous temperature –
-
do not touch it.
While using the machine, never unscrew or remove the cap while under pressure (1). Before
-
removing it, make sure that it does not give off steam anymore by shutting the boiler off, and
pressing the steam iron button (7) to release all remaining steam.
The machine has a special heating element. Only qualified technician should replace it.
-
The safety cap (1) must be replaced with original parts only.
-
сайт: парогенератор-пээ.рф Тел.: +7(499)112-45-65
English
Pag. 5