MBNLED PRO CONTROLLER RGBAW MULTI 3G+ L513513G5 Bedienungsanleitung Seite 38

，INPUT CONTROL MODE – ANALOGUE
The device works in 0/1-10V mode, if the jumper on the PCB is in correct state.
See page 34.
SETUP–
0/ 1-10V –
MANUAL –
SINGLE –
，INPUT CONTROLE MODE –
The device works in DALI mode, if the jumper on the PCB is in correct state.
See page 35.
SETUP–
DALI –
MBN GmbH, Balthasar-Schaller-Str. 3,
Downloaded from www.Manualslib.com
Access to the setup menu items
Channel control via analog input signal
Desired colour can be adjusted manually with the buttons
Standalone programs can be selected
Access to the setup menu items
Channel control via DALI commands, auto addressing via DALI commands, or manual DALI
addressing
DALI addresses setting:
Press the ENTER button.
The first channel number starts to blink. With the UP-DOWN buttons you can now select the address
from 1-64. By pressing the ENTER button, the next channel number starts to blink. For every
channels should be set different channel number, other way the DALI system will not work correctly.
Press the ESC button to save the changes.
manuals search engine
Bedienungsanleitung / Users manual
0/1-10V，
DALI，
86316 Friedberg - Germany
www.proled.com
38