Changing The Single Hotkey - G&D DVIMUX8-USB Installation Und Bedienung

Changing the single hotkey

Press the hotkey and the
KVM switch. Pressing the hotkey and the select key simultaneously enables the
switching of channels.
If an application program or another G&D device uses the same hotkey within the
cascade, the hotkey can be changed.
NOTE:
How to change the current hotkey:
Downloaded from www.Manualslib.com
Backspace
The single hotkey Ctrl
1. Press the Hotkey+Backspace
vate the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the setup keys listed below to enable a certain hotkey:
Ctrl  enables Ctrl hotkey
Alt  enables Alt hotkey
Alt Gr  enables Alt Gr hotkey
Win  enables Win hotkey
Shift  enables Shift hotkey
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Switch mode of the service port is
enabled. Enter » #! « to switch to the setup menu.
2. Use the or
Arrow Arrow
3. Press the key (repeatedly) to enable a certain hotkey:
Space
 enables Ctrl hotkey
Ctrl
 enables Alt hotkey
Alt
 enables Alt Gr hotkey
Alt Gr
 enables Win hotkey
Win
 enables Shift hotkey
Shift
4. Press the key to save your settings.
S
manuals search engine
key simultaneously to start the setup mode of the
is preset at default.
(default: Ctrl+Backspace
keys to select the
Hotkey
Configuration
) simultaneously to acti-
entry.
G&D DVIMUX8-USB · 19