Changing The Select Keys - G&D DVIMUX8-USB Installation Und Bedienung

Changing the select keys

In the default settings, use the enabled select keys
puters that are connected to the KVM switch.
For instance, you can switch to computer 2 by pressing
How to choose a different select key set:
Downloaded from www.Manualslib.com
1. Press Hotkey+Backspace
the setup mode.
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the setup keys shown below to activate the desired set of select
keys to switch between computers 1 to 8:
1  enables select keys 1, 2, 3, 4, 5, 6, 7, 8
NUM 1  enables select keys NUM 1, [...],NUM 7, NUM 8
Z  enables select keys A, B, C, D, E, F, G, H
F1  enables select keys F1, F2, F3, F4, F5, F6, F7, F8
1. Use the terminal emulator to establish a connection to the KVM switch.
If the setup menu is not displayed, the Switch mode of the service port is
enabled. Enter » #! « to switch to the setup menu.
2. Use the Arrow or Arrow
3. Press the Space key (repeatedly) to enable the particular set of select keys to
switch between computers 1 to 8:
1 ... 8  enables select keys 1, 2, 3, 4, 5, 6, 7, 8
 enables select keys NUM 1, [...],NUM 7, NUM 8
NUM 1 ... 8
 enables select keys A, B, C, D, E, F, G, H
A ... H
 enables select keys F1, F2, F3, F4, F5, F6, F7, F8
F1 ... F8
4. Press the key to save your settings.
S
manuals search engine
to
1 8
(default: Ctrl+Backspace ) simultaneously to enable
keys to select the Select Keys
Configuration
to switch between the com-
(default:
Hotkey+2 Ctrl+2
entry.
G&D DVIMUX8-USB · 21
).