Network Settings (Wired); Network Settings (Wireless) - Eminent Em7180 Hdmedia Rt2 Benutzerhandbuch

3. Go to 'HDMI Output' and press the 'OK' button. Select 'Raw' if the HDMI cable is
connected to a digital HDMI receiver which can decode all audio codecs. Select
'LPCM Dual CH' if the HDMI cable is connected to your television. Select 'LPCM
Multi CH' if the EM7180 is connected to a HDMI receiver which can not decode
all audio codecs.
4. Go to 'SPDIF Output' and press the 'OK' button. Select 'Raw' if the SPDIF cable
is connected to a SPDIF digital receiver which can decode all audio codecs.
Select LPCM Dual CH' if your digital receiver can not decode all audio codecs.
5. Press the 'Return' button.
Note: All devices can play back (L)PCM audio. RAW audio is intended for an external
receiver, and required for a full theatre set up with 5.1 speakers. If you only use a TV,
simply set PCM Dual Channel audio.

6.6 Network Settings (wired)

If you have skipped the network settings during the initial setup, or you want to change
the network settings, you can use the following steps.
1. Go to 'Network' and press the 'OK' button.
2. Select 'Wired Lan Setup' if you have connected the EM7180 using a network
cable. If a DHCP server is available in your network, select 'DHCP IP (Auto)' and
press the 'OK' button to receive an IP-Address from the DHCP server.
3. Select 'Fix IP (Manual)' and press the 'OK' button if there is no DHCP server
active or in case you want to setup the IP-settings manually. If the manual option
is chosen, please make sure the IP-Address data is in range with the current
network.
4. Press the 'Return' button.
Note: If the wired or wireless network is not connected, it is normal for a message
'DHCP NOT READY' to appear in this menu.

6.7 Network settings (wireless)

The EM7180 can also be used wirelessly. In order to be able to use the wireless
connection, a wireless USB stick needs to be used. This wireless USB stick is not
supplied.
1. Insert the wireless USB stick. A notification saying the WIFI adapter has been
found appears.
2. Go to 'Network' and press the 'OK' button.
3. Select 'Wireless Setup' and press the 'OK' button.
4. Select 'Connection1' and press the 'OK' button.
5. Select 'Infrastructure (AP) and press the 'OK' button.
6. The EM7180 starts searching for wireless networks within range. The
network(s) will be shown.
28 |
ENGLISH