Safety Notes - Aventics LP04 Betriebsanleitung

AVENTICS | LP04 | R402001614–BDL–001–AC
10
1

Safety notes

Please observe these safety notes!
Please observe the notes on safety and familiarize
yourself with the contents of the operating
instructions before installing the devices and
connecting them to a compressed air supply or the
power supply.
Only use the devices in the specified areas and
systems and comply with the tolerances listed in the
technical data.
In order to avoid accidents, electrical start-up is to be carried out only in a pressure-free state.
Only start the devices after they are completely assembled as well as correctly wired, and tested.
If the limit values listed in the technical data are not observed or are exceeded, the devices may
overheat or be completely destroyed, the functions and/or electrical safety may be impaired.
To comply with the technical data, only use the cables that are listed in the operating instructions or in
the project drawings.
The devices may only be opened by trained personnel. ESD-compliant components.
Plug connectors may not be plugged in or pulled out under load. Switch off the power supply before
connecting or disconnecting plugs to avoid damaging the electrical parts.
In order to attain the correct protective class and be able to use all the functions in the system, please
take care that all seals are whole and correctly placed.
The protective class can only be attained if all of the plug connections that are not being used are
closed (caps/dummy plugs).
The power supply must be isolated according to DIN EN 60742, classification VDE 0551. Please
observe any specifications on external fuse protection.
Appropriate transport, and correct storage, setup and installation are required for the devices to work
safely and without failure.
Please observe the relevant DIN/VDE standards or country-specific regulations when installing the
system/device. Especially observe: VDE 0160 (DIN EN 50178), VDE 0100
Switches and configurations may not be changed during operation. Changed settings are only
accepted once the device has been switched off and on again.
Downloaded from www.Manualslib.com manuals search engine
Installation and initial start-up may only be
performed in a voltage- and pressure-free state and
by a qualified technician. Please comply with the
installation position in the operating instructions.
The devices are normally only intended for use in
industrial applications. If the devices are used in
domestic applications (domestic, business, and
commercial applications), then a permit must be
obtained from the authorities or test office.
WARNING