Specifications - Ingersoll-Rand 308 Serie Gebrauchsanweisung

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
USING THE TOOL (Continued)
•
When starting with a cold wheel, apply it to the
work slowly until the wheel gradually warms up.
Make smooth contact with the work and avoid any
bumping action or excessive pressure.
•
Models 308 and 308–EU Die Grinders have a free
speed of 25 000 rpm when operated at 90 psig
(6.2 bar/620 kPa) air pressure. Operation at higher
air pressure will result in excessive speed.
•
Always match collet size with accessory shank size.
LUBRICATION
Ingersoll–Rand No. 50
Always use of an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International – No. C18–C3–FKG0
For USA – No. C18–03–FKG0–28
After each two hours of operation, if an air line
lubricator is not used, inject 1/2 to 1 cc of Ingersoll–Rand
No. 10 Oil into the Air Inlet.
Model
308, 308–EU
H
Tested in accordance with ANSI S5.1–1971 at free speed
♦ Tested in accordance with ISO8662–1 with artificial unbalanced load at 50% of rated speed for ungoverned tools and at
80% rated free speed for governed tools.
•
ISO3744
WARNING LABEL IDENTIFICATION
90 psig
(6.2bar/620 kPa)
PLACING TOOL IN SERVICE
Ingersoll–Rand No. 67

SPECIFICATIONS

Collet Speed/rpm
1/4" 25,000
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
•
Always insert tool shank no less than 10 mm in the
collet. Tighten Collet Nut securely to prevent
accessory from working out during operation of
the Grinder. Check tightness of Collet Nut before
operating the Grinder. Pay particular attention to
the fact that allowed speed of a mounted point is
lowered when the length of the shaft is increased
between end of collet and mounted point
(overhang).
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
HSound Level
dB (A)
Pressure
95.1
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905–1)
♦Vibrations Level
•Power
m/s
108.1 2.6
2