Product Description; Functions Overview; Operation - ANSMANN 1001-0080 Bedienungsanleitung

PRODUCT DESCRIPTION (SEE PAGE 2)
1 Charging compartment
indicator
2 Rechargeable battery type
3 Charge level
4 END indicator
5 Charging current
6 Timer
7 mAh indicator
8 Voltage indicator

FUNCTIONS OVERVIEW

• Single-slot monitoring
• Automatic recognition of Li-Ion and NiMH/NiCd rechargeable
batteries
• Automatic charging start when batteries are inserted with correct
polarity
• Micro controller-monitored charge control
• Automatic charging stop for fully charged rechargeable batteries
• Recognition of defective rechargeable batteries
• Display of incorrectly inserted (reverse polarity) rechargeable
batteries
• Detailed status display
• Trickle charge for NiMH rechargeable batteries
• Discharge function and capacity measurement
• Adjustable charging current
• 5 V USB connection, max. 2 A

OPERATION

Simple charging
1. Connect the power supply cable with the power supply connection
on the charger.
2. Connect the power supply to a suitable wall outlet.
3. Slide back the charging contact and insert the rechargeable
battery heeding correct polarity (negative terminal (-) on charging
contact) into the charging compartment.
4. If you do not wish to make any further settings, the product will
begin charging with 500 mA charging current after 8 seconds.
5. Once the rechargeable battery is fully charged, the display will
show the END indicator.
6. Remove the rechargeable battery and disconnect the product from
the power supply.
Deutsch |
9 Mode
10 USB input
11 Power supply connection
12 MODE button
13 CHANNEL button
14 CURRENT button
15 Charging compartment
16 Charging contact
17 Power supply unit
English | Français | Español | Português
Svenska | Italiano | Nederlands
13