Inhaltsverzeichnis
Werbung
Safety instructions
Notice
Please read this manual carefully before attempting the assembly or installation of your new ceiling fan.
To ensure a safe and successful installation, please make sure to read this manual, ensure it is on hand for
your installer to refer to, and keep in a safe place for future reference.
1.
Please read this manual carefully before attempting the assembly or installation of your new ceiling fan.
2.
ALL electrical work should only be carried out by a suitably qualified and licenced electrical contractor. This ceiling fan MUST be
installed ONLY by a suitably qualified and licenced electrical contractor.
3.
This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person
responsible for their safety.
4.
Do NOT allow children to play with this appliance, and supervise children around electrical devises at all times.
5.
Before commencing any electrical work, ensure the power is disconnected and/or the mains switched off at the circuit box and ensure
all pole isolation of the power supply.
6.
The fixing point for your ceiling fan must be of sound construction, undamaged, and capable of supporting a load of 35Kg, or 4 times
the weight of the fan plus the method of attachment, whichever is greater. Verifying the stability of the mounting structure is the sole
responsibility of the consumer and qualified installer.
7.
Care needs to be taken to ensure the installation location does not allow the fan blades to come into contact with any object or
surface. There must be a minimum of 30cm clearance between the blade tip (end) and the nearest wall or object. Reduced clearances
to walls or ceilings can also reduce the amount of air your fan can move.
8.
The installation should also allow for a clearance of 2.1m between the floor and the bottom of the blades. The installation should
allow for a minimum of 3.0m between ceiling fans.
9.
The fan and the hanging bracket must be earthed.
10. The fan must be connected to a mains supply only. Fans connected to alternate power systems such as Solar, Wind, Battery etc will
not be covered under the terms of this warranty.
11. Use ONLY the EGLO controller supplied with your fan, or a suitable EGLO controller designed specifically for your fan. Use of non-
standard, non-EGLO or solid-state dimmer type controllers can cause inferior performance, and permanently induce a humming
noise in your fan motor which cannot be repaired, and which will not be covered under warranty.
12. Do NOT change the direction of your fan whilst it is spinning. ONLY change the direction after the fan blades have come to a complete
stop.
13. Do NOT insert any object into the fan blades whilst in operation, as this can cause damage to the fan, and personal injury.
14. Do NOT use ceiling fans and gas appliances in the same room at the same time.
15. All EGLO products are warranted to be free from defects in workmanship and materials provided the products are used with a voltage
supply within the range the product is designed to operate.
16. This fan is designed for use indoors only, though can be installed in suitable undercover and protected outdoor areas.
17. EGLO lighting will not be liable for any advice given to the consumer from any of our suppliers or third parties, related or otherwise.
18. Proper performance relies on the right fan being correctly installed in the optimum location. Fans that do not perform as expected
and which are not faulty cannot be replaced or exchanged under warranty.
19. The important safeguards and instructions in this manual are not designed to cover every possible condition or circumstance. It is
understood that common sense, caution and care are factors that cannot be built into the product, those using and maintaining this
product must supply these factors.
5
BONDI Ceiling Fan
Werbung
Inhaltsverzeichnis
