Adjustment Mode / Alignment Of The Pillars - FIESSLER RAZL-2CO Handbuch

People Counter RAZL-2CO (Translation)

6.1 Adjustment mode / Alignment of the pillars

The supplied cover template should be located on the reflector pillar. The red lines symbolise the 2 light beams of the counting light barrier.
Incorrect
Traffic light flashes white
Pillars are slightly twisted to each other
Sensor pillar must be turned slightly anti-
clockwise until the traffic light flashes green
Correct
traffic light flashes green
Pillars are aligned in a plane parallel alignment
The alignment must still be checked
(see following section
Adjustment mode / Check alignment).
Fiessler Elektronik GmbH & Co. KG
Buchenteich 14, D-73773 Aichwald
Incorrect
Traffic light flashes yellow
Pillars are slightly twisted to each other
Turn the sensor pillar slightly clockwise until the
traffic light flashes green
Incorrect
traffic light flashes green
Sensor pillar offset to the left
The pillars must be aligned in one line.
-30-
Phone: +49 (0)711 - 91 96 97 - 0
Fax: +49 (0) 711 - 91 96 97 - 50
Incorrect
Traffic light flashes red
Pillars are significantly twisted to each other or
one pillar is completely covered
The pillars must be aligned in a parallel plane.
Incorrect
traffic light flashes green
Sensor pillar offset to the right
The pillars must be aligned in one line.
Internet: http://fiessler.de
E-Mail: info@fiessler.de