Commissioning Single Pillar (Standalone); Wlan Connection / Single Pillar (Standalone); Set The Operating Mode Of The Pillar (Standalone); Configuration - FIESSLER RAZL-2CO Handbuch

People Counter RAZL-2CO (Translation)

3 Commissioning single pillar (standalone)

After plugging the connection cable into a 230 V earthed socket, the traffic light is illuminated blue during the starting
process ca. 1 minute.

3.1 WLAN connection / single pillar (standalone)

Step 1: Select "WLAN" in the Settings menu of the mobile device. After a short time, all available WLAN connections are displayed.
Step 2: Select WLAN with the name "RAZL-serial number of the sensor pillar" (the serial number is located on the nameplate of the sensor
pillar)
Step 3: Enter preset WLAN password "fiessler#razl".
Step 4: A message may appear on the mobile device that an Internet connection is no longer possible.
It must be selected that the WLAN connection is retained.
If the mobile device is connected to this WLAN, an Internet connection with the mobile device is no longer possible until the connection to this
WLAN is terminated.

3.2 Set the operating mode of the pillar (Standalone)

Step 1: Start setup wizard
Step 2: Define pillar as single pillar
Assign a new WLAN pass-
Step 3:
word

3.3 Configuration

Step 1: Wait until the traffic light colour changes from blue to another colour.
Step 2:
In the mobile device, select WLAN with the name "RAZL-serial number of sensor pillar" and enter a new WLAN password
Reload the page "http://razl.lan" or "http://10.1.10.1" in the browser address bar
Step 6:
Step 7:
In the menu
Select device overview
Select setting wheel
Start device configuration
"Installation of the counting light barrier..." and "Type of use" must be set. Incoming and outgoing persons can only be detec-
ted correctly if the setting corresponds to the actual installation location of the pillars and their use as an entrance and/or exit.
Fiessler Elektronik GmbH & Co. KG
Buchenteich 14, D-73773 Aichwald
As soon as the traffic light colour changes, the sensor pillar provides a WLAN for mobile
devices with a web browser such as a smartphone, tablet or notebook for configuration.
Open the Internet browser of the mobile device
Enter "http://razl.lan" or "http://10.1.10.1" in the address bar and confirm
The setup wizard is started
Select language
Select operating mode "Standalone / Independent RAZL-WLAN Hotspot"
Change WLAN password and apply settings
After the settings have been accepted, the pillar is restarted
Lock symbol (top right)
Phone: +49 (0)711 - 91 96 97 - 0
Fax: +49 (0) 711 - 91 96 97 - 50
-24-
Internet: http://fiessler.de
E-Mail: info@fiessler.de