Start-Up / Pillar Connection (Master-Slave); Set Operating Mode Of The Main Pillar (Master); Setting The Operating Mode Of The Auxiliary Pillars (Slave); Coupling Pillars - FIESSLER RAZL-2CO Handbuch

People Counter RAZL-2CO (Translation)

4 Start-up / pillar connection (master-slave)

Plug the connection cables of all sensor columns into 230 V shockproof sockets. During the starting process,
the traffic lights turn blue for about 1 minute.

4.1 Set operating mode of the main pillar (Master)

Connect the mobile device to
Step 1:
the first pillar
Step 2: Start setup wizard
Step 3: Define pillar as master
Step 4: Assign a new WLAN password

4.2 Setting the operating mode of the auxiliary pillars (slave)

Connect the mobile device to
Step 1:
the second pillar
Step 2: Define pillar as slave
Transfer WLAN data from
Step 3:
the main pillar
possibly connect and define
...
with further pillars

4.3 Coupling pillars

Connect mobile device to mas-
Step 1:
ter pillar
Step 2: Activate configuration
Fiessler Elektronik GmbH & Co. KG
Buchenteich 14, D-73773 Aichwald
As soon as the traffic light colour changes, the sensor pillars each provide a WLAN for
mobile devices with web browsers such as smartphones, tablets or notebooks.
Select "WLAN" in the Settings menu of the mobile device. After a short time all available WLAN con-
nections are displayed
Select WLAN with the name "RAZL-serial number of the 1st sensor pillar" (the serial number is
located on the nameplate of the sensor pillar)
Enter preset WLAN password "fiessler#razl".
A message may appear on the mobile device that an Internet connection is no longer possible.
It must be selected that the WLAN connection is retained. If the mobile device is connected to this
WLAN, an Internet connection with the mobile device is no longer possible until the connection to this
WLAN is terminated.
Open the Internet browser of the mobile device
Enter "http://razl.lan" or "http://10.1.10.1" in the address bar and confirm
The setup wizard is started
Select language
Select operating mode "Main pillar (Master) / Independent RAZL-WLAN Hotspot"
Change WLAN password and apply settings
After the settings have been accepted, the pillar is restarted
In the mobile device, select WLAN with the name "RAZL-serial number of the 2nd sensor pillar"
Enter preset WLAN password "fiessler#razl".
Reload the page "http://razl.lan" or "http://10.1.10.1" in the browser address bar
The setup wizard is started
Select operating mode "Auxiliary pillar (slave) / member of a RAZL-WLAN hotspot"
Enter the WLAN name (SSDI) of the main pillar (master)
Enter the WLAN password of the main pillar (master) and accept the settings
After the settings have been accepted, the pillar is restarted
... (as steps 1 to 3)
Wait until the traffic light colour changes from blue to another colour.
In the mobile device, select WLAN with the name "RAZL-serial number of master pillar" and enter a
new WLAN password
Reload the page "http://razl.lan" or "http://10.1.10.1" in the browser address bar
Lock symbol (top right)
Phone: +49 (0)711 - 91 96 97 - 0
Fax: +49 (0) 711 - 91 96 97 - 50
-26-
Internet: http://fiessler.de
E-Mail: info@fiessler.de