Extremis Hopper AA Montageanleitung Seite 6

ASSEMBLING HOPPER
7. Fasten the bench frames to the table legs
in the way described above. Then tighten
all the nuts using the supplied spanner.
8. Put the optional felt mats under the
table legs.
ASSEMBLING BACK REST
1. Unscrew the nuts at the outside of the
bench frames. The nut on the inside will
prevent the bench from falling.
6 assembly hopper - assembly back rest - floor fastening
2. Slide the back rest supports over the
two threaded rods. In case of steel legs,
retighten the nuts. In case of aluminium
legs, use the nuts supplied with the
back rest.
CAUTION: Only use the supplied
spanner to tighten the nuts. Do not
fasten them too tightly:
MAX. 10Kg
3. Screw the wooden backrest to the
supports, each time using three screws.
Use the pre-drilled holes to correctly
position the back rest.
20lbs