Philips Azur GC4800 Serie Bedienungsanleitung Seite 21

Problem
The iron
does not
produce any
steam.
The iron
does not
produce a
steam boost.
Water
droplets drip
onto the
fabric during
ironing.
39_000_8233_2_DFU-Luxury_A6_v3.indd 21
Possible cause
There is not
enough water in
the water tank.
The steam control
is set to position 0.
The iron is not hot
enough and/or the
drip-stop function
has been activated.
You have used
the steam boost
function too often
within a very short
period.
The iron is not hot
enough.
You have not closed
the cap of the filling
opening properly.
ENGLISH
Solution
Fill the water tank (see chapter
'Preparing for use', section
'Filling the water tank').
Set the steam control to a
position between 1 and 6
(see chapter 'Using the appliance',
section 'Steam ironing').
Set an ironing temperature that
is suitable for steam ironing
(2 to MAX). Put the iron
on its heel and wait until the
temperature light has gone out
before you start ironing.
Continue ironing in horizontal
position and wait a while before
you use the steam boost function
again.
Set an ironing temperature at
which the steam boost function
can be used ( 3 to MAX).
Put the iron on its heel and wait
until the temperature light has
gone out before you use the
steam boost function.
Press the cap until you hear a
click.
21
3/20/14 9:26 AM