thermocoax FG200 Serie Montageanleitung Seite 7

__________________________________________________________________________________
b.) Process for braided cable:
Repeat steps 1 through 3 according to figure 1a.), adding the following operation for
1.
either termination under shrinking sleeve or with cable lug.
Remove braid using needle and twist remaining wires at approximately 45 mm at end
2.
of cable (Picture 13). Cut twisted braid 10 mm from end of cable. Slide translucent
shrinking sleeved over end with braid beneath and shrink to fit (Picture 14).
Optional Assembly with cable lug for earth termination. Do not cut twisted braid and
3.
slide beneath shrinking sleeve. Crimp cable lug onto drilled braid taking the wires
double about 5 mm for better fit (Picture
Picture 13
4. Repeat steps 4 through 5 according to figure 1a.), adding the following operation for
termination with braid.
5. Remove braid using needle and twist remaining wires at approximately 80 mm at end
of cable (Picture 16).
Use green yellow shrinking tube (if necessary cut to length) and place over drilled
6.
braid. Use hot air gun to shrink to fit. Place large short shrinking tube black centred
over stripped cable ends including green yellow tube. Use hot air gun to shrink to fit
(Picture 17). Strip conductor wire insulation on insulated ends 7 mm and use crimp
tool to assemble wire end sleeves (Picture 18). If terminated right the green yellow
part should be slightly longer than the conductors
Picture 16
15).
Picture 14
.
Picture 17
Picture 15
Picture 18
7 | P a g e - S e i t e