__________________________________________________________________________________
Picture 37
Picture 40
4. Cut cold lead cable to desired length and strip outer sheath by 30 mm (Picture 43).
Strip conductor wires 7 mm and crimp to heating cable conductors using connectors
(Picture 44). Place small shrinking tubes (30 mm) centred over crimp connections and
shrink to fit using hot air gun (Picture 45).
5. Place large shrinking tube black (120 mm) centred over connection of cable. Shrink to
fit using hot air gun (Pictures 46 to 48).
6. Strip 70 mm at termination side of cold lead cable (Picture 48). Place large short
shrinking tube (50 mm) centred over stripped cable end and shrink to fit using hot air
gun (Picture 49). Indent shrinking tube using thin flat pliers (Picture 50).
Picture 43
Picture 38
Picture 41
Picture 44
Picture 39
Picture 42
Picture 45
11 |
P a g e - S e i t e