Bosch Sensixx B22L TDS2240 Gebrauchsanleitung Seite 21

problem possible causes
Dirt comes out • There is a build up of scale or
through the minerals in the steam tank.
soleplate.
• Chemical products or additives
have been used.
The iron does not • The boiler is not switched on or
produce any steam. the water tank is empty.
• The steam regulation is set to the
minimum position.
The ironed garment • The selected temperature is too
turns dark and/or high and has damaged the
sticks to the garment.
soleplate.
The soleplate turns • This is a regular consequence of
brown. continued use over a long period
of time.
The appliance • Water is being pumped into the
makes a pumping steam tank.
sound. • The sound will not stop.
Loss of pressure Steam release button has been
during ironing. activated for too long a period of
time, that is, it has been pressed
too frequently.
Water spots appear May be caused by steam
on the garment condensed on the ironing board.
during ironing.
Water spots appear Water spots are caused by steam
on the garment condensation in the hose when
during use of the cooling down after use.
"PulseSteam"
function.
The hose gets hot This is normal. It is caused by the
during use. steam passing through the hose
during steam ironing.
Water leakage from Filter (4) located at the side of the
the boiler. appliance is loose.
The iron does not "PulseSteam" function has been
stop steaming after activated by double click.
placing it on the pad
(2).
If the above does not solve the problem, get in touch with an authorised technical service.
You can download this manual from the local homepages of Bosch.
Solution
• Use tap water mixed 50% with distilled
or demineralised water. To prolong the
optimum steam function, mix tap water
with distilled water 1:1. If the tap water
in your district is very hard, mix tap
water with distilled water 1:2.
• Clean the soleplate with a damp cloth.
• Never add products to the water.
• Set the main power button (13) to the
"I" position, and/or fill the water tank.
• Increase the steam flow (see section B).
• Select a suitable temperature for the
material being ironed and clean the
soleplate with a damp cloth.
• Clean the soleplate with a damp cloth.
• This is normal.
• If the sound will not stop, do not use
the steam generator and contact an
authorised technical service centre.
Use the steam release button at
intervals. This improves the ironing
result as the textiles will be steamed,
dried and ironed properly.
Wipe the textile cover of the ironing
board, and iron any water drops to dry
them.
Water drops stop coming out of the
soleplate after using the "PulseSteam"
function for some time.
Place the hose on the opposite side so
that you cannot touch the hose during
ironing.
Tighten up the filter.
Just press the trigger once again and
the iron will stop steaming at once.
21
BOSCH