Correct Use - Meister MOF1200-1 Originalbetriebsanleitung

7 Mounting rails (2 x) for rip fence
8 Depth limiter
9 Depth stop locking screw
10 Depth stop with scale
11 Depth stop adjustment setting
12 Speed control
13 Engine housing ventilation slots
14 Locking lever
15 Handle (left)
16 Milling chuck with integrated collet
chuck
17 Chip extraction port with adapter
18 On/off switch
19 Rip fence with two guiding rods
20 Copy casing
21 Collet chuck
22 Centring pin
23 Spanner
4 – Correct use
The router is used for manual routing of
solid hard­ and softwoods in the home.
It is not intended for heavy­duty use in
commercial and industrial construction
work.
Any other use is dangerous and improper
and will invalidate liability and warranty
claims!
The router is not intended for commercial
or industrial use.
Intended users
The router is intended for use by home
handypersons with appropriate experi­
ence and skills.
This unit may not be used by people
(including children) with reduced physi­
cal, sensory or mental capacities, with a
lack of experience and without the
appropriate knowledge, unless they are
58
MW-5458010-Bedien-2004.indd 58 MW-5458010-Bedien-2004.indd 58
supervised by someone who is respon­
sible for their safety or have been
instructed by such a person with regard
to how the unit is to be operated. Chil­
dren should be supervised to ensure
that they do not play with the device.
Materials suitable for machining
Solid seasoned hard­ and softwoods as
well as wood composites, free of foreign
bodies such as nails, screws or mortar
residues.
Permitted ambient conditions
The router is intended for use in
dry indoor areas not exposed to
extreme climatic conditions. It is not
suitable for use in potentially explosive
environments!
The machine is intended only for use in
the household.
Improper use of the product
All applications carried out with the device
that are not listed in the „Correct use"
chapter will be considered improper use.
Uses for which the tool is not designed
may cause risks and injury. Do not use
accessories that are not intended spe­
cifically for this electrical tool.
Just because you can affix an accessory
to your electrical tool, there is no guar­
antee it is safe to use.
The permitted revolutions of the tool
insert must be at least as high as the
highest value specified on the electrical
tool. Accessories that turn faster than is
permitted may break and fly off.
27.04.20 10:05 27.04.20 10:05