Eng; Power On And Off - Streetz TWS-0001 Handbuch

ENG

Overview
3.
4.
5.
1. Ear tips, large/medium/small
2. LED/Microphone
3. Multi-function button
4. Charge connectors
5. LED

Power on and off

Take the earbuds out of the charging case,
they will automatically power on.
Place the earbuds in the charging case to
automatically power them off.
Or press and hold both multi-function
buttons for about 5 seconds to power
them on or press and hold 1 multi-
function button for about 5 seconds
to turn them off.
Charge
For first time use, take out the
earbuds.
Insert the earbuds into the
charge case to charge them.
The charge connectors should
be well connected.
Charge the charging case via a Micro
USB cable.
The earbuds' LEDs will be lit red while
charging.
The earbuds' LEDs will be lit white for
60 seconds when fully charged
The charge case's LEDs will be lit
blue, 1 LED = 20% charged, 2 LEDs =
50% charged, 3 LEDs = 75% charged,
4 LEDs = 100% charged.
1.
2.
Connect
1. Take out the earbuds from the case. They will power on
and connect to each other.
2. The left earbud's LED flash red and blue indicating ready for
connection.
3. Connect to the earbuds from your phone/device.
Refer to your phone/device manual if needed.
Usage
Gently put the earbuds into your ears with microphone towards
to the front of the ear.
Answer and hang up a phone call
Press the multi-function button to answer or hang up a
phone call.
Decline a phone call
Press and hold the multi-function button for about 2 seconds.
Switch audio output
During a call, press and hold the multi-function button for about
2 seconds to switch audio output between phone and earbuds.
Mute on/off
During a call, press the multi-function button 2 times to turn
mute on or off.
Play/Pause
Press the multi-function button to play/pause.
Previous song
Press the multi-function button 3 times for previous song.
Next song
Press the multi-function button 2 times for next song.
Redial last number
Press the multi-function button 4 times to redial last number.
Reset connection
1. Turn off the earbuds.
2. Press and hold the multi-function buttons for about 10 seconds.
The LEDs will flash red and white, and then power off.
3. Turn on the earbuds. (White LED flashes)
The earbuds will connect to each other.
4. The left earbud's LED flash red and blue indicating ready for
connection.
5. Connect to the earbuds from your phone/device.
Refer to your phone/device manual if needed.
Warning
1. Never disassemble or modify the product to avoid damage
to the product and to avoid danger.
2. Do not store in extreme temperatures (below 0°C or over
45°C).
3. Keep away from children.
4. Do not use harsh chemicals or strong detergents when you
clean this product.
5. Keep dry.
1