Sport-Tec move 5.0 Bedienungsanleitung Seite 11

DISPLAY
The display turns on as soon as the pedals are moved. You can manually switch on the
display by pressing the red button.
After 4 minutes of inactivity (no movement is detected) the display switches off
automatically.
The following information can be displayed:
· Training time (T),
· Distance (D),
· Completed revolutions (C),
· Total revolutions (T-C),
· Calories burned (CAL),
· Training time, distance, completed revolutions, total revolutions and
calories burned alternately (SCAN).
By pressing the red button in succession, you can activate / deactivate SCAN-mode and
switch between the different display modes.
RESET DISPLAY
To reset all values, press and hold the red button for 4 seconds. The total revolutions (T-C)
will only reset when the battery voltage is interrupted.
TRAINING TIME (T)
To display the training time, press the red button below the display until the arrow
() points to „T" but „SCAN" is not flashing. If „SCAN" is flashing, all information is
displayed alternately.
Display format: 00:00 - 99:59 (HR:MIN)
DISTANCE (D)
To display the distance you have completed, press the red button below the display
until the arrow () points to „D" but „SCAN" is not flashing. If „SCAN" is flashing, all
information is displayed alternately.
Display format: 0.000 - 0.999
COMPLETED REVOLUTIONS (C)
The Mini Exercis Bike move 5.0 counts the revolutions. To display the completed
revolutions, press the red button below the display until the arrow () points to „C" but
„SCAN" is not flasing. If „SCAN"is flashing, all information is displayed alternately.
Display format: 0 - 9999
Sport-Tec GmbH ∙ Tel.: +49 (0) 63 31 14 80-0 ∙ Web: www.sport-tec.de