Remote Control; Controls - Atag CU1050SMR Bedienungsanleitung

USE

Remote control

Controls

EN 6
Connecting the remote control to the built in unit
If the built in unit cannot be operated with the remote control, e.g. after
the battery has been changed, the connection between the remote
control and the built in unit must be re established.
1. Press and hold the '+' button.
2. Attach the built in unit to the mains voltage.
▷ A long audible signal sounds. The remote control has been
connected to the appliance.
Note: If no audible signal sounds within 30 seconds, repeat this
procedure.
Switching on the fan
1. Press the '+' button.
▷ The extractor starts at setting 2.
▷ Setting 2 appears on the led status bar.
Adjusting the extractor capacity
1. Press the '-' or '+' button to select a higher or lower setting.
▷ The selected setting appears on the led status bar.
▷ The maximum setting you can select is the intensive setting 4.
The run time of the intensive setting is 4 minutes. Once this time
has elapsed, the fan switches back to level 2.
Switching Off the fan
1. Press the '-' button until the built in unit switches Off or press the
Off /Clean air button.
Switching lighting on and off
1. Press the light button.
▷ The lighting switches on.
2. Press the light button again and the lighting switches off.
Dimming the lighting
1. To dim the lighting, press and hold the light button until the dimmer
function is activated.
▷ The lighting comes on at maximum intensity and it decreases as
long as you hold down the button.