Replacing The Lamp; Troubleshooting - AEG DDE5960B Benutzerinformation

5.2 Cleaning the charcoal filter
The charcoal filter can be washed once in
two months.
To remove the filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in
this chapter.
2. Remove the clips holding the filter
bed (1), then the filter bed (2).
2
3. Wash the filter bed in hot water
without using detergent or use a
dishwasher.
Set the dishwasher without
using rinse aids or any other
detergents. The dishwasher
cannot be filled with dishes.

6. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
6.1 What to do if...
Problem
You cannot activate the ap-
pliance.
1
Possible cause
The appliance is not connec-
ted to a power supply or it is
connected incorrectly.
4. Dry the filter bed.
WARNING!
Do not use oven to dry the
filter bed!
5. To install the filter, perform the steps
in reverse order.
Replace the filter bed every 2 years or
when the cloth is damaged.
5.3 Filter alarm
Refer to activating and
deactivating the filter alarm
in daily use chapter.
Refer to cleaning the grease
filter in this chapter.
Refer to cleaning the
charcoal filter or replacing
the charcoal filter (depends
on filter type).
To reset the alarm:
Touch the for 3 seconds.

5.4 Replacing the lamp

This appliance is supplied with a LED
lamp. This part can be replaced by a
technician only. In case of any
malfunction refer to "Service" in the
"Safety Instructions" chapter.
Remedy
Check if the appliance is cor-
rectly connected to the elec-
trical supply.