Installation Instructions; Operating Your Wine Cooler - La Sommeliere TR2V150 Gebrauchsanweisung

➢ Before Using Your Wine Cooler
• Remove the exterior and interior packing.
• Before connecting the Wine Cooler to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
➢ Installation of Your Wine Cooler
• This appliance is designed to be for free standing installation or built-in (fully
recessed) (Refer to sticker location the back of this appliance).
• Place your Wine Cooler on a floor that is strong enough to support it when it is
fully loaded. To level your Wine Cooler, adjust the front leveling leg at the
bottom of the Wine Cooler.
• Locate the Wine Cooler away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause the unit not to perform properly.
• Avoid locating the unit in moist areas.
• Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet.
Do not under any circumstances cut or remove the third (ground) prong from
the power cord. Any questions concerning power and/or grounding should be
directed toward a certified electrician or an authorized Products service center.
The Wine Cooler should be placed in where the ambient temperature is between 16-
32°C. If the ambient temperature is above or below this range, the performance of the
unit may be affected. For example, placing your unit in extreme cold or hot conditions
may cause interior temperatures to fluctuate. The range of 5-20℃ may not be reached.
The above temperatures may fluctuate depending on whether or not the interior bulb
is ON or OFF or whether the bottles are located on the upper/middle or lower section.

INSTALLATION INSTRUCTIONS

OPERATING YOUR WINE COOLER

20