METREL MD 9930 Benutzerhandbuch Seite 18

METREL MD 9930 Settings Menu
Figure 4: Measure menu
Spot: Measure the center point temperature. Highlight and press Select to turn on or
off.
Hot: capture maximum temperature in the image. Highlight and press Select to turn
on or off.
Cold: capture minimum temperature in the image. Highlight and press Select to turn
on or off.
Emiss
Set emissivity and reflected temperature for accurate temperature measurements.
Use Up and Down buttons to highlight the menu, then press Select to open.
Emissivity: Set Custom by highlighting it, pressing Select to open, then use Up and
Down to set. The available range is 0.01–0.95 in steps of 0.01. A value for a material
can be chosen in the drop down menu. Navigate to it using Up and Down then press
Select to use.
Reflected temperature: set by selecting, then using Up and Down buttons. See
chapter Reflected Temperature for more information.
Figure 5: Setting the emissivity
18