Operation - Metrel Md 9930 Benutzerhandbuch

METREL MD 9930

Operation

5. Operation
Charging the Battery
Before you use the thermal camera for the first time, charge the battery for a
minimum of one and one-half hours. The battery status shows on the four-segment
charge indicator.
To charge the battery:
Connect the AC power adapter into a wall outlet and connect the DC output to the
thermal camera's charging port. The charge light turns on. The battery indicator
  
eventually goes through changes " " as the battery charges.
Continue charging until the indicator becomes and the charge light turns off.
Disconnect the power adapter when the battery is full charged.
WARNING
Make sure that the thermal camera is near room temperature before you connect it to
the charger. Do not charge in hot or cold areas. When you charge in extreme
temperature, battery capacity may be decreased.
Power on and off
To turn the thermal camera on, push the Power Button. When thermal camera is
powered on, push and hold the Power Button for two seconds to turn the thermal
camera off.
NOTE
The thermal camera needs sufficient warm-up time for the most accurate
temperature measurements and best image quality. This time can vary by
environmental conditions. It is best to wait a minimum of 10 minutes for the best
results.
Desktop
The desktop is as follows:
Figure 1: Camera desktop
Lens and camera field of view
This table lists the horizontal Filed of view (FOV), vertical FOV and IFOV for lens.
11