Troubleshooting; Disposal Considerations; Declaration Of Conformity - Klarstein 10028303 Bedienungsanleitung

Cleaning the Dust Filter & Cooling Pad
• The evaporative cooler's fi lter and cooling pad will need to be removed prior to
cleaning. Once all of the different components have been cleaned, place them
back into the unit in this order: water tank, cooling pad and dust fi lter. To prevent
clogging of the dust fi lter, we recommend cleaning the fi lter at least once a month.
• To clean the dust fi lter, remove it from the back of the unit by pushing down on
the two tabs located above the fi lter and pull it out. Gently scrub it with a soft
brush and rinse with water. Allow it to thoroughly air dry before placing it back in
the unit. To clean the cooling pad, fi rst remove the dust fi lter to expose the pad.
Remove the cooling pad from the back of the evaporative cooler, rinse it with
clean water and allow it to thoroughly air dry before placing it back into the unit.
Problem
There is no air-
fl ow.
The unit does
not cool at all.
Cooling is not
suffi cient.
According to the European waste regulation 2002/96/EC this symbol on the product
or on its packaging indicates that this product may not be treated as household was-
te. Instead it should be taken to the appropriate collection point for the recycling of
electrical and electronic equipment. By ensuring this product is disposed of correct-
ly, you will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate waste handling of
this product. For more detailled information about recycling of this product, please
contact your local council or your household waste disposial service.
Your product contains batteries covered by the European Directive. 2006/66/EC, which cannot be
disposed of with normal household waste. Please check local rules on separate collection of batteries.
The correct disposal of batteries helps prevent potentially negative consequences on the environ-
ment and human health.
Producer: CHAL-TEC Vertriebs- + Handels GmbH, Wallstraße 16, 10179 Berlin.
This product is conform to the following European Directives:
2012/206/EU (ErP)
2004/108/EG (EMC)
2011/65/EU (RoHS)
2006/95/EG (LVD)
9

Troubleshooting

Possible Cause(s)
The power cord is not
plugged in.
The water tank is not locked
into the unit.
There is insuffi cient water in
the tank.
The cooler/humidifi er button
was not pressed.
The pump is defective.
The cooling pad is not suffi -
ciently saturated with water.

Disposal Considerations

Declaration of Conformity

Possible Solution
Check to make sure the plug is plugged into
an outlet. The unit should beep twice once the
power supply is connected.
Make sure the water tank is locked into the
back of the unit.
Check the water level in the tank and make
sure there is enough water.
Press the COOLER/HUMIDIFIER button.
Contact customer service if there is an issue
with the water pump.
Wait a few minutes for the cooling pad to be
fully saturated with water.