Wireless Remote Control; Troubleshooting; Maintenance And Storage - Pulsar Helion Bedienungsanleitung

21

WIRELESS REMOTE CONTROL

(bought separately)
Wireless remote control (RC) duplicates the POWER ON function, digital
zoom, video start/stop and menu navigation.
The RC controls are:
ON Button (15): duplicates the functions of the ON (11) button.
Button (16): digital zoom activation. Function PiP.
Button (17): duplicates the functions of the REC (7) button.
Controller (18): duplicates the functions of
the М (9) button when pressed; duplicates
the functions of the UP (10)/ DOWN (8)
upon rotation (in hot menu/main menu).
22
TECHNICAL INSPECTION
Check:
External view (there should be no cracks on the housing).
The state of the objective and eyepiece lenses (there should be no
cracks, spot, dust, deposits etc. ).
The state of the Battery Pack (should be charged) and electric
terminals (there should be no oxidation ).
Correct functioning of the controls.
23

MAINTENANCE AND STORAGE

Maintenance should be carried out no less frequently than twice a
year, and should consist of the following measures:
Wipe external plastic and metal surfaces clean of dust and dirt with
a soft cloth moistened with a synthetic cleaning agent.
Clean the electric terminals of the Battery Pack and device's
battery slot using a grease-free organic solvent.
Check the objective and eyepiece lenses. If required, remove dust
and sand (preferably by a noncontact method). Clean the external
surfaces of the lenses with products expressly designed for this
purpose.
Store the device in a carrying case. Remove the Battery Pack
for long-term storage.
23
17
16
15
18
24

TROUBLESHOOTING

The table presented below lists some potential problems that may occur
when using the device. If a problem encountered with the device is not
listed, or if the recommended action does not resolve the problem, the
unit should be returned for repair.
Problem Check
The thermal imager Battery Pack is discharged.
will not turn on.
The unit does not USB cable is damaged.
operate on external
External power supply is
power supply.
discharged.
The image is blurry, Calibration is required.
with vertical stripes
and uneven
background.
The image is too Brightness or contrast level
is too low.
dark.
Poor image quality / Problems described may arise in adverse weather conditions
Detection range (snow, rain, fog etc.).
reduced.
Smartphone or tablet Password in the unit was
PC cannot be changed.
connected to the
device.
The device cannot Remote control is not
be powered on activated.
with wireless remote Low battery.
control.
When using the Because of variations in thermal conductivity, objects
scope at below zero (surrounding environment, background) under observation
temperatures the become warm more quickly at above-zero temperatures, which
image quality is allows higher temperature contrast and, thus, the quality of the
worse than at image produced by a thermal imager will be better.
At low operating temperatures, objects under observation
positive
(background) normally cool down to roughly identical
temperatures.
temperatures, which leads to lower temperature contrast, and to
image quality (precision) degradation. This is normal for thermal
imaging device.
Follow the link to read FAQs on thermal vision
http://www.pulsar-nv.com/support/faq/
Corrective action
Charge the battery.
Replace USB cable.
Charge the external power
supply (if necessary).
Carry out calibration according
to Section 9 "SENSOR
CALIBRATION".
Adjust brightness/contrast with
the UP/DOWN buttons.
Delete network and connect
again inserting the password
saved in the device.
Activate the remote control
according to instructions.
Install a new CR2032 battery.
24