Usb Connection - Pulsar Helion Bedienungsanleitung

Scenario 2. «Display off» is on, the device needs to be turned off.
Hold down the ON button. Message "Display off" with countdown
appears (1,2,3)
Hold down the ON button until the device turns off (the device turns off
after 1 is reached).
18
FUNCTION PiP
PiP ("Picture in Picture") allows you to see a zoomed image
simultaneously with the main image in a dedicated window.
Turn on/off the PiP function with a long press of the DOWN (8) button.
Change zoom ratio in the PiP window with a short press of the DOWN
button.
The zoomed image is displayed in a dedicated window, with the full
optical magnification being shown.
The main image is shown with optical magnification ratio which
corresponds to ratio x1.0.
When PiP is turned on, you can operate the standard and continuous
digital zoom. The full optical magnification will take place only in the
dedicated window.
When PiP is turned off, the image is shown with the optical
magnification set for the PiP function.
19
STREAM VISION
HELION thermal imagers support Stream Vision technology which
allows you to stream an image from the display of your thermal imager to
a smartphone or PC tablet via Wi-Fi in real time mode. You can find
further guidelines on Stream Vision in a separate booklet or at our web
site www.pulsar-nv.com
Note: The Stream Vision application allows you to update the software
features of your thermal imager.
Scan the QR codes to download Stream Vision free of charge:
Google Play (Android OS):
21
iTunes (iOS):
20

USB CONNECTION

Connect one end of the USB cable to the Micro-USB (4) port of your
device, and the other end to the USB port of your PC/laptop.
Turn the device on with a short press of the ON (11) button (device
that has been turned off cannot be detected by your computer).
Your device will be detected by the computer automatically; no drivers
need to be installed.
Two connection modes will appear
on the display:
Memory card (external memory)
and Power.
Select connection mode with UP
and DOWN buttons.
Confirm selection with a short press of the M button.
Connection modes:
Memory card (external memory). In this mode the device is
detected by the computer as a flash card. This mode is designed for
work with the files saved in device's memory. The device's functions
are not available in this mode; the device turns off automatically.
- If video recording was in progress when connection was made,
recording stops and video is saved.
Power.
In this mode PC/laptop is used as an external power supply. The
status bar shows icon
functions are available.
Note: The Battery pack installed in the device is not being charged!
USB disconnection.
When USB is disconnected from the device where connection is in
the USB Mass storage device mode, the device remains on the OFF
state. Turn the device ON for further operation.
When USB is disconnected from the device when in the Power mode,
the device keeps operating with Battery Pack, if available, and it has
sufficient charge.
USB connection
Use as power
Use as memory card
. The device continues operating and all
22