Pulsar Helion Bedienungsanleitung Seite 11

Wi-Fi – off (default password)
=
Digital zoom – off
=
PiP – off
=
Colour palette – White Hot
=
Unit of measurement - metric
=
Warning: date and time settings, default pixel map
and remote control activation are not restored.
Lens selection is used when replacing objective
lenses for the models: HELION XP28; HELION
Lens XP38; HELION XP50.
selection
Selection of the lens type is important for the correct
display of the optical magnification and adequate
operation of the Stadiametric rangefinder.
Replace the objective lens: to do this, move the
=
latch (13) backwards, turn the lens counter
clockwise all the way and remove the lens.
Install a new lens, move the latch backwards and
=
move clockwise until the latch snaps.
= Enter the submenu with a short press of the M
button.
With a short press of the UP/ DOWN buttons
=
select the desired lens: 28; 38 or 50.
= Confirm selection with a long press of the M
button.
Remote control activation (bought separately)
Before operating the remote control (RC),
Remote
remember to activate it as follows:
Control
Press the M button, countdown starts (30 sec),
=
within which hold down for two seconds any RC
button.
If activation is successful, the message
=
«Connection complete» appears
If error occurs the message «Connection failed»
=
appears
The RC is activated and ready for use.
=
Defective pixel repair
When operating a thermal imager, defective (dead)
Defective
pixels (bright or dark dots with constant brightness)
pixel repair
may become visible on the sensor. HELION thermal
imagers allow the user to repair defective pixels on
the detector using a software-based method or to
abort deletion.
15
.
. Repeat the procedure.
Enter the submenu with a short press of the M
=
button.
Select icon
=
A marker
=
display.
On the right side of the display appears
=
"magnifying glass" – a magnified image in a frame
with a fixed cross
detection of a defective pixel and to match the
pixel with the marker, horizontal and vertical
arrows for X and Y axes showing marker's
movement
With a short press of the UP/ DOWN buttons
=
move the marker to align it with a defective pixel.
Switch the direction of the marker from horizontal
=
to vertical and vice versa with a short press of the
M button.
Align the defective pixel with the fixed cross in the
=
frame – the pixel should disappear.
Delete the defective pixel with a short press of the
=
REC (7) button.
A brief message "OK" appears in the frame in
=
case of success.
Then you can delete another defective pixel by
=
moving the marker along the display.
Exit "Defective pixel repair" option with a long
=
press of the M button.
Return to default defective pixel pattern
This option allows you to cancel deletion of the
defective pixels and return them to the original
state.
Enter the submenu with a short press of the M
=
button.
Select icon
=
Select "Yes" if you wish to return to default
=
defective pixel pattern, or "No" if you do not.
Confirm selection with a short press of the M
=
button.
This option allows the user to view the following
information about the device:
Full name
Device
=
information
SKU number
=
serial number
=
software version
=
+
with a short press of the M button.
appears on the left side of the
, designed for easier
.
x=95
y=99
and press М.
16