Milking; Milking With Automatic Or Manual Cluster Removal - Nedap MPC-2 Bedienungsanleitung

Within 2 sec
MPC-2
Downloaded from www.Manualslib.com

3. Milking

3.1 Milking with automatic or manual cluster removal

From the washing or stand by mode activate the milking mode by pressing the
function key release cluster .
It is also possible to enter the milking mode simultaneously for all MPC-2 s in
a row. To do so first press the Shift-key followed, within 2 seconds, by the
function key release cluster .
The display shows the actual cow number on the left, milk yield on the right.
There are two options; milking with automatic removal or milking with manual
removal :
Press function key automatic removal , to start milking with automatic
cluster removal.
Or:
Press function key manual removal , to start milking with manual cluster
removal.
In both cases, the MPC-2 will now lower the cluster, attach cluster.
During the milking process three horizontal dashes appear on the sixth position
on the display. These dashes indicate the milking with automatic removal and
represent the phases described below. The dashes will disappear according to
these phases from top to bottom.
An h symbolises milking with manual removal .
After attaching the cluster, the milking process can be divided into three
phases:
1. Neutral start time: during this phase the cow is allowed to get her milk flow
going.
2. Milk measuring: period of normal milking.
3. Wait for removal: when the milk yield drops below a certain predefined
threshold value, the vacuum will be shut-off.
In case of automatic removal the cluster will be removed automatically at
the end of phase 3.
Or:
In case of manual removal the display starts flashing and the MPC-2 will
wait until the milker presses the release cluster key.
manuals search engine
19
English