Operation - HANSGROHE Metropol S 14020-Serie Montageanleitung

Attention! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the slide washer, washer and collar nut
over the hose and threaded base and tighten
the collar nut by hand.
4. Tighten screws.
5. Connect the supply pipes to the isolation valves;
cold right - hot left.
6. Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal
pressures.

Operation

The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
T h i s m i x e r s e r i e s - p r o d u c e d
waterdimmer (flow limiter)
®
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Test certificate:

English
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa.
If the continuous water heater causes any problems or
there is not enough flow of water, the waterdimmer
(6a) located behind the aerator must be removed.
To adjust the hot water limiter on single lever mixers,
please see page 13.
No adjustment is necessary when using a continuous
flow water heater.
Spare parts (see page 3)
1
1.1 screw cover
2
3
4
5
6
7
8
9
w i t h
10 lever arm cpl. 340 mm
11 handle Metris S
7 l/min 0,3 MPa
14 l/min 0,3 MPa
Special accessories
max. 1 MPa
X
0,1 - 0,5 MPa
1,6 MPa
XXX = Colors
max. 80° C
65° C
000 chrome plated
WRAS
880 satin chrome
handle Metropol S
flange
nut
cartridge cpl.
seal
aerator cpl.
fixing set
connection hose
pull rod
special tool set
(order as an extra)
®
14895XXX
96338000
97406XXX
97209000
92730000
95008000
13912XXX
13961000
96316000
96657XXX
96324000
31093000
58085000