Herunterladen Diese Seite drucken

THERMEx Kubisma CKB 800 Bedienungsanleitung Seite 33

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 42
Kubisma is equipped with a loft flange, cable, flexible pipe Ø160 mm.
NB. Electric installations must be carried out by an authorized electrician.
Before installing Kubisma carry out the following preparations:
Establish an outlet to the open either through the ceiling or the wall.
(One might use the ceiling hose to mark the hole)
Ceiling Hose (fig 1)
After correct marking and establishment of the outlet hole the ceiling hose is fastened to
the ceiling with 4 Rawlplugs and 4 screws.
Electric Connection (230 V)
The lead is internally led through the chimney to an electric connection.
For models with internal engine there is one cable marked with 230 V.
For models without engines there are two cables:
One marked with 230 V.
One marked engine.
(Here an extension lead is installed which should be used for the connection to the plug
from the external engine).
In case of direct connection to the electric net (without socket), it is necessary that a
multipolar switch is between the cooker hood and the electric net. The switch is to have a
minimum distance of 3 mm between the contacts and is to be dimensioned according to
power current regulations.
Installation of Flexible Hose (fig 2)
The flexible hose (D160 mm) is led through a hole in the ceiling or the wall and is installed
on the roof cowl or the wall flange. If you have chosen an external engine the installation of
flexible hose (D160 mm) will be for induction flange on roof ventilator, ceiling ventilator or on
external wall ventilator.
Installation Height
The installation height is individual, but it is recommended to have 50-60 cm above an
electric stove and 70 cm above a gas cooker. (Measured from the edge of the table to the
filter of the canopy).
Chimney Installation (fig 3)
If the chimney is too long it must be shortened on top with a hacksaw
or an angle grinder.
The chimney/canopy is subsequently fastened to the ceiling hose with 4 screws.
Wall model must also be fastened on the wall (below) (4).
English
33

Werbung

loading

Diese Anleitung auch für:

Kubisma ckb 1200Kubisma ckb 2000