Philips PowerPro Uno FC6170 Bedienungsanleitung Seite 8

ENGLISH
8
Problem
The appliance does
not work when I push
the button.
The vacuum cleaner
has a lower suction
power than usual.
Dust escapes from the
vacuum cleaner.
The brush does not
turn anymore.
Cause
The battery light flashes fast
because the batteries are low.
You cannot use the appliance
because the appliance is still
charging.
You have to press two buttons.
The filter and the cyclone are
dirty.
You have not connected the
dust bucket, the dust separator
and the cyclone properly.
Incorrect assembly of these parts
causes air leakage, which leads to
loss of suction power.
The filter is dirty.
The brush has encountered too
much resistance.
Solution
To charge the batteries, insert the
small plug into the socket on the
appliance and insert the adapter into
a wall socket.
You have to remove the small plug
from the socket on the appliance
before you can switch on the
appliance.
First press the on/off button to
switch on the appliance. Then press
the MAX button to get maximum
suction power.
Clean the filter and the cyclone.
Connect the dust bucket, the dust
separator and the cyclone properly.
Clean the filter.
Clean the brush.