Assembly - Greencut GLM680X Betriebsanleitung

ASSEMBLY

ATTENTION: The lawn mower is supplied without fuel and oil in the engine. Your new lawn mower
has been tested at the production site which means that the engine can contain a small amount of
residual oil.
ASSEMBLY OF THE HANDLEBAR
1. Carefully unfold the mower's handlebars, taking care not to pinch or damage the machine's control cables.
2. Remove the two locking knobs on the lower handlebar. Position the lower handlebar by aligning the side
holes with those on the mower at the back of the cover.
3. Insert the two bolts and knobs on each side and secure until tight.
4. Unfold the upper handlebar bar and remove the locking knobs. Place the handlebar over the lower handles
by aligning the holes in the upper handlebar with the holes in the lower handlebar.
5. Insert the two locking knob bolts through the lower handlebar and then through the holes in the upper
handlebar.
1
ASSEMBLY OF THE COLLECTION BASKET
Attach the plastic basket clips to the mower's metal frame. Make sure these clips are fully secured to the frame.
2
Basket cover
Frame
3
Basket
75
EN