Assembly; Panel Installation - Greencut GLM770SX Betriebsanleitung

84

ASSEMBLY

ATTENTION: The lawn mower is supplied without fuel and oil in the engine. Your new lawn mower
has been tested at the production site which means that the engine can contain a small amount
of residual oil.
ASSEMBLY OF THE HANDLEBAR
Insert the lower part of the handlebar into the corresponding hole and secure it with the screws. Then remove the lower
handlebar locking handles and insert the upper part of the handlebar so that the holes match. Secure the handlebars
by inserting and adjusting the locking handles.

PANEL INSTALLATION

Install the plastic panel using screws. The screws you use to adjust the panel at the top are shorter than the screws you
use to adjust the bottom.