Assembly - Greencut GLM560L-16 Betriebsanleitung

ASSEMBLY

UNFOLDING AND ADJUSTING HANDLE ASSEMBLY
A. To raise handle assembly:
• Pull up and back on the lower handle (F) until it is
aligned with the hole position of the arm support and
the mower housing.
• To secure the lower handle (F) in place, lock the lower
screw (M).
• Open the upper cam locks (H).
• Pull up and back on the upper handle to raise it into
operating position.
• To secure the upper handle in place, close the upper
cam locks (H).
NOTE: If the upper handle is loose or
separated from the lower handle, tighten
the knobs on the upper handle locks by
turning them clockwise.
B. To lower the handle assembly:
• Open the upper cam locks (H).
NOTE: If the handle lock is difficult to
open, loosen the knobs on the upper
handle
counterclockwise.
• Lower the upper handle.
• Unfix the lower screw (M).
• Fold the handle to the front of the unit.
• Avoid pinching or trapping any cables.
INSTALLING THE MULCHING PLUG (FOR MULCHING OPERATION)
NOTE: When using the mulching plug (B),
do not install the grass catcher.
• Remove battery.
• Lift and hold the rear discharge door (N).
• Grasp the mulching plug (B) by its handle and insert it
at a slight angle.
• Push the mulching plug (B) securely into place.
• Lower the rear discharge door.
• Reinstall battery when you are ready to mow.
locks by turning them
H
B
55
EN
F
M
N