Factory Settings - Loewe Assist Multi-Control Bedienungsanleitung

Setting operating mode
Setting the STB button
Brand list
The button with the STB function can be set to the desired device with a
3-digit number.
➠
When entering an invalid code the LED lights up for 2 seconds.
➠
The setting procedure is cancelled after 10 seconds without a code
input.
➠
In addition to the STB button you can also assign the STB function to
the DVD and AUDIO buttons (page 25).
➠
If you do not find a code with which you can operate your STB device
in this search, make the Internet Update (page 27).

Factory settings

The STB/DVD/AUDIO button can be reset to the factory settings.
- 26
Press the STB button for at least 5 seconds.
The LED above the STB button flashes twice.
Enter code 003.
The LED above the STB button flashes twice.
Enter the three-digit code from the Brand list of page
189.
Press the On/Off button until the device to be operated
reacts to the inputs on the remote control.
Press the OK button.
Press the button for at least 5 seconds.
The LED above the button flashes twice.
Enter code 000.
The LED above the button flashes twice.